 |


GT-6U-VME
Commercial & Rugged Hybrid Signal Processing 6U VME/VXS (VITA 41) Board

Technical Specifications

Board Architecture
FPGAs
- 2 Altera® Stratix® II GX FPGAs supported by ATLANTiS FrameWork
- Up to 16 full-duplex, high-performance, multi-gigabit transceivers
- Up to 132,540 equivalent LEs
- Over 6.7 Mbits of RAM
- Up to 63 DSP blocks, 252 embedded multipliers, and 8 PLLs
Processors
- 4 Analog Devices ADSP-TS201S DSPs
- Up to 500 MHz, 2 ns instruction rate DSP core
- 3 GFLOPS (32-bit floating point) or 12 GOPS (16-bit fixed point) per DSP
- Native support for 32-bit floating point operations and for 8, 16, and 32-bit fixed point operations
- 24 Mbits of on-chip RAM per DSP
- 4 4-bit LVDS link ports at up to 1 GByte/s per DSP
- Integrated I/O processor with 15 channel DMA controller per DSP
External Memory
- Up to 3 GBytes of DDR2 SDRAM (6 banks, up to 512 MB each)
- 128 MBytes Flash memory for booting DSPs and configuring the FPGA
BittWare FINe™ Host/Control Bridges
- 32-bit, 33 MHz PCI interface
- GigE to front and rear panel
- Supports host- and Flash-based booting of Stratix II GX FPGAs and ADSP-TS201S
- Runs BittWorks server for full remote access via the BittWorks Toolkit
Link Ports
- 8 link ports extend from the ADSP-TS201S DSPs (two per DSP) to the Stratix II GX FPGA (666 MBytes/s each)
- 8 link ports (two per DSP) dedicated for interprocessor communication (1 GByte/s each)
Rear Panel I/O
- GigE to VME P2 (via FINe)
- 12 channels of high-speed SerDes transceivers to VME P0
- 47 LVDS pairs to VME P2
- RS-422 to VME P2
Front Panel I/O
- 4 channels of high-speed SerDes
- transceivers to Infiniband type connector RS-232/422
PrPMC+ Interface
- Compatible with standard PMC modules
- Additional connector (J4) provides 64 signals factory configurable to Stratix II FPGA or rear panel (can be used as 32 differential pairs)
- XMC site with 8 SerDes channels (4 to each Stratix II FPGA)
PCI-VME Bridge
- Tundra Tsi148 PCI-VME bridge with 2eSST support
- Interfaces VME64x backplane to on-board 64-bit, 33 MHz PCI local bus
Size
- 6U single slot (160mm x 233mm)
Development Tools
BittWorks Tools for Application Development
- BittWorks Toolkit - host, command, and debug tools for BittWare hardware
- BittWorks Porting Kit - source code and prebuilt ports for porting the BittWare Toolkit to other operating systems
- BWIO - software library for controlling I/O on BittWare boards
FPGA and DSP Code Development
- Analog Devices VisualDSP++
- Altera Quartus® II software
Accessory Boards
- BittWare GTV6-BORT rear transition module for rear panel I/O breakout
- BittWare GXBO breakout board for front panel I/O access

|
 |

Products & Services
FPGA & DSP Hardware


|